With the continuous acceleration of the urbanization process, in order to meet the promotion needs of various industries, various streets and lanes are occupied by various full-color LED displays. This also has a problem that everyone is more concerned about. What is the working principle of led display?
To understand the working principle of the led display, you must first figure out the various signal trends of the led display. There are mainly 5 kinds of signals in the led display. These 5 kinds of signals must cooperate to complete the data transmission in order to complete the display. The display works. The editor of Winbond Ying will introduce the functions of 5 kinds of signals.
Full color led display
LED full-color display principle and signal trend analysis
The led display is composed of three parts: data acquisition system, control system, and display system. The direction of the data signal is: Peripheral-Computer-DVI graphics card-Data sending card-Data receiving card-HUB adapter board-Display screen.
The actual situation is that the HUB adapter board is the last link of data transmission, and all signals can be found on the HUB adapter board. The HUB adapter board is a card board that divides the signal from the control board into several branches, also called a splitter board. Under normal circumstances, it is determined according to the longitudinal number of the LED electronic screen itself.
The various signals contained in the display. The signal starts from the HUB board and is connected to the unit board or module through the flat cable to complete the data transmission. Except for the serial transmission of data signals, all other signals are transmitted in parallel. Now analyze the effects of various signals as follows:
1. CLK clock signal:
The shift pulse provided to the shift register, each pulse will cause the data to be shifted in or out of one bit. The data on the data port must be coordinated with the clock signal to transmit data normally, and the frequency of the data signal must be 1/2 times the frequency of the clock signal. In any case, when the clock signal is abnormal, it will make the whole board display disorderly.
2. STB latch signal:
When the data transmission of one channel is completed, the STB latch signal is valid, the data in the shift register is latched, and the data content is displayed by lighting the LED through the driving circuit. However, since the drive circuit is controlled by the EN enable signal, the precondition for its lighting must be that the enable is turned on. The latch signal also needs to be coordinated with the clock signal to display a complete image. In any case, when there is an abnormality in the latched signal, the entire board will be displayed in a disorderly manner.
Full color led display
3. EN enable signal:
The entire screen brightness control signal is also used for screen blanking. Just adjust its duty cycle to control the change of brightness. When the enable signal is abnormal, the entire screen will appear dark, dark, or tailing.
LED full-color display principle and signal trend analysis
4. Color data signal:
Provide the data needed to display the image. It must be coordinated with the clock signal to transmit the data to any display point. Generally, the red, green and blue data signals are separated in the display screen. If a data signal is short-circuited to the positive or negative pole, the corresponding color will appear full or not bright. When the data signal is suspended, the corresponding color will be displayed. The situation is uncertain.
5. ABCD line signal:
It only exists during dynamic scanning display. ABCD is actually a binary number, and A is the lowest bit. If the ABCD signal is expressed in binary, the maximum control range is 16 lines (0000-1111). In 1/4 scanning, only AB signal is enough. Because the AB signal range is 4 lines (00-11). When the line control signal is abnormal, there will be display misalignment, highlighting or image overlap, etc.
