RS485 adopts balanced transmission and differential reception methods, and has the ability to suppress common mode interference. In addition, the bus transceiver has high sensitivity and can detect voltages as low as 200mV. Therefore, the transmission distance of RS485 is up to kilometers away, which is for long-distance serial data. Mode of transmission.
RS485 adopts half-duplex working mode. The half-duplex network composed of RS485 interfaces uses shielded twisted pair for signal transmission. Physically only two wires are required, which is very convenient for multi-point interconnection to realize one-to-multi-point communication. . The RS485 interface bus can connect 32 stations, and up to 255 stations can be connected after adding a repeater.
The RS485 interface sending end uses the voltage difference between the two wires of the differential signal line plus 2V to plus 6V to represent logic "1", and -2V to -6V to represent logic "0".
At the receiving end of the RS485 interface, the differential signal line where A is higher than B by more than 200mV is considered as a logic "1", and A is lower than B by more than 200mV as a logic "0".
The signal level of the RS485 interface is lower than that of RS232, which is not easy to damage the interface circuit chip. At the same time, the signal level of the RS485 interface is compatible with the TTL signal level, making it easy to connect to TTL circuits.
The high transmission rate of RS485 data is 10Mbps, but considering the need to connect devices with various interfaces (such as RS232, etc.), and too high transmission rate will reduce the transmission distance, so the transmission rate in practical applications is often set to 9600bps or lower.
RS485 interface connector adopts DB9 9-pin socket or HT508 socket type terminal, which is easy to connect to the equipment.

